TIRE DECAL INSTRUCTIONS - Read everything before starting!

1) Remember - these decals are fragile, so be careful.

2) Prep the tire as required. If you think you need to spray a gloss coat on first, that's OK, but it
   isn't really necessary.

3) Trim close to the lettering. I use curved cuticle scissors that can be found in the "Beauty" department
   of Wally Mart.

4) Hold the decal under a trickle of water until it comes loose on its own.

5) Lay the backing paper on the tire in approximately the correct position, and slide the decal off from one end.

6) Carefully adjust the decal until it is in the right position. Blot with a dry paper towel.

7) After 5 minutes, flow on a coat of Microscale Liquid Decal Film, trying NOT to touch the decal with the brush.
   This will stick the decal to the tire.

8) Allow to dry at least 15 minutes before adding any additional decals to the tire.
  (like the " Racer" half of the American Racer decals)

9) When done, and completely dry, spray with a Matte Clear Acrylic spray (Wally Mart craft department).